Set up and connect
Siphon The connection position
tie with
a
hose clamp
(24-40 mm) bore
gene.
4.6 Adjusting
the device
To
reduce noise and vibration and to
avoid walking of the device, place the
device horizontally.
1.
Turn the lock nuts clockwise with a
wrench with a spanner width of
17.
Washbasin The
water drainage
feeding tube with
a bend
fix and drill
gene.
→
"Accessories",
Page 28
Plastic stand
pipe with rubber
run muff or a
drain
The water drainage
feeding tube with
a bend
fix and drill
gene.
→
"Accessories",
Page 28
2.To adjust the device, turn the device
feet. Check the horizontal
adjustment of the device with a
spirit level.
Connect the device electrically
Remark:
Your home electrical
installation for this appliance must
comply with local legal and safety
regulations and must include an
earth leakage circuit breaker.
1.Plug the power plug of the
device's power cord into a power
socket near the device.
All
device feet must be firmly on the
ground.
The connection data
of the device
can
be found in the technical data
→
Page 52
.
2.
Check the mains plug for tightness.
16
To Next Page
Loading...
