Set up and connect de
The device has an aqua sensor.
CAUTION!
Objects left in the drum that are not
intended for use in the device can
cause property damage and damage
to the device.
▶ Before operating these items
en and remove the supplied
accessories from the drum.
a The aquasensor checks during
the degree of cloudiness of the
rinsing water and adjusts the
duration and number of rinsing
cycles accordingly.
3.3 Energy saving mode
1. Completely remove packaging material
and protective covers from the device.
If you do not operate the device for a
long time, the device automatically
switches to energy-saving mode. All
displays go out and
flashes.
The energy-saving mode is ended by
operating the device again, e.g. B.
open or close the door.
If you do not operate the device in
energy-saving mode for a long time,
the device switches off automatically.
For the environmentally friendly
disposal of the packaging material,
please refer to the information on
the subject
→
"Dispose of packaging",
Page 12.
2. Check the device for visible damage.
3. Open the door.
→
"Basic Operation",
Page 44
Note: The device does not switch off
automatically when Wi-Fi is activated.
4th Remove the accessories from the
drum.
5. Close the door.
A. 4thSetting up and connecting
Set up and
Connect
Set up and connect
4.1 Unpack the device
Note: Note the information on
security
→
page 4
and avoid property damage
the →
Page 11,
to use your device
safely.
13
To Next Page
Loading...
