de Basic operation
3. Unfold the laundry and place it in
the drum.
13.7 Start the program
4. Note: Make sure that no laundry
is jammed in the door.
Note: If you want to change the time
until the end of the program, first
set the Ready in time.
Close the door.
▶ Press.
a The drum turns and it
a load detection follows, which
can take up to 2 minutes and then
the water runs in.
a The display shows either pro
duration or the Ready in time is
displayed.
13.6 Add detergent and care
products
For programs in which intelligent
dosing is not possible or desired, you
can add detergent via the
compartment for manual dosing.
13.8 Adding laundry
Note: Note the information on
security
→
page 4
and avoid property damage
the →
Page 11,
to use your device
safely.
Note: Note the information on
security
→
page 4
and avoid property damage
the →
Page 11,
to use your device
safely.
Tip: In addition to intelligent dosing,
you can also add other care products
for laundry, such as laundry
detergents, to the chamber for
manual dosing. Add stain remover,
starch or bleach. To avoid overdosing
or foaming, do not add any additional
detergent to the manual dispensing
compartment.
1. Press.
The machine pauses and checks
whether you can add or remove
laundry. Note the program status.
2. Add or remove laundry.
3. Close the door.
4th Press.
Pre-condition: Find out about the
optimal dosage for detergents and
care products.
→
Page 42
13.9 Abort the program
After the program has started, you can
cancel the program at any time.
1. Pull out the detergent drawer.
Note: Note the information on
security
→
page 4
and avoid property damage
the →
Page 11,
to use your device
safely.
2. Pour in the detergent.
→
"Detergent drawer",
Page 21
3. Fill in the care product if necessary.
1. Press.
2. Open the door.
4th Slide in the detergent drawer.
At high temperatures and high
water levels, the door remains
locked for safety reasons.
46
To Next Page
Loading...
