Set up and connect de
4.5 Connect the device
2. Connect the water inlet hose to the
tap (26.4 mm = 3/4 ").
Water inlet hose
connect
Hints
¡ Note the information
on the subject of security →
page 4
and avoid property damage
→
Page 11,
to keep your device safe
need to be able to.
¡ Make sure you do that
Connect the device to a water inlet
with a safety device against
drinking water contamination
through backflow (according to DIN
EN 1717). The connection valves /
water taps provided for this are
equipped with this safety device if
the building is properly installed.
¾˝
min.
10mm
min.
17mm
3. Carefully open the tap and check
whether the connection points are
tight.
Connection types water drain
The information will help you to
connect this device to the water drain.
1. Connect the water inlet hose to the
device.
Note: Note the information on
security
→
page 4
and avoid property damage
the →
Page 11,
to use your device
safely.
2
1
CAUTION!
When pumping out, the water
drainage hose is under pressure and
can come loose from the installed
connection point.
▶ The water drain hose against
Secure unintentional loosening.
Note: Note the pumping heights.
The maximum pump head is
100 cm.
Process in one
siphon
The connecting
pose with a
Hose clamp
(24-40 mm) si-
to cherish.
17th
To Next Page
Loading...
