safety de
1.4 Secure installation
When installing the device, follow the safety instructions.
WARNING - Risk of Electric Shock!
Improper installations are dangerous.
▶ Only connect and operate the device in accordance with the
information on the nameplate.
▶ Only connect the device to a power supply with alternating
current via a properly installed socket with earthing.
▶ The protective conductor system of the electrical house installation
must be installed according to regulations. The installation must have
a sufficiently large cable cross-section.
▶ When using a residual current circuit breaker, only use one
type with the symbol.
▶ Never supply the device via an external switching device, e.g.
B. timer or remote control.
▶ When the device is installed, the mains plug of the mains
connection cable must be freely accessible, or if free access is not
possible, an all-pole disconnecting device must be installed in the
fixed electrical installation in accordance with the installation
regulations.
▶ When setting up the device, make sure that the power cord
is not pinched or damaged.
Damaged insulation of the power cord is dangerous.
▶ Never bring the power cord into contact with hot device parts
or heat sources.
▶ Never bring the power cord into contact with sharp points or
edges.
▶ Never kink, crush or modify the power cord.
5
To Next Page
Loading...
