Siemens WM14UP40 - Intelligent Dosing System; Filling the Dosing Tank; Contents of the Dosing Container

de Intelligent dosing system
1
Intelligent dosing system
5 intelligent dosing
system
3. Liquid detergent
Fill the detergent into the
appropriate dispenser.
→ "Detergent drawer",
Page 21
and soft
I. A.Intelligent dosing system
Depending on the program and the
settings, the optimum quantities for
liquid detergent and fabric softener
are automatically dosed.
15.1 Filling the dosing tank
Note
To use the smart dosage, fill the
Dosing tank.
¡ Only fill the dosing container
with suitable detergents and care
products → Page 42.
¡ If you use the liquid detergent
or change the fabric softener,
empty and clean the dispensing
container beforehand.
→ "Clean the detergent drawer-
gen ", page 55
¡ If you have both dosing containers for
If you want to use liquid detergent,
adjust the contents of the
dispenser → Page 48 a.
4th Close the filler caps.
Note: To prevent the detergent
from drying out or drying out, do
not leave the filler cap open for a
long time.
5. Slide in the detergent drawer.
6th The basic dosage
→ Page 49 adjust.
Pre-condition: / flashes.
15.2 Contents of the dosing container
1. Pull out the detergent drawer.
Hints
¡ If you know the contents of the dosing
change container, the basic
dosage for this dosage container is
reset.
¡ If you have both dosing containers for
If you use liquid detergent, you
must select a dispenser to be
used during washing.
2. Open the filler cap.
Adjust the contents of the
dosing container
1. 3 seconds on i-Dos
to press.
2. Around set to i-Dos
to press.
a The display shows.
48