de Cleaning and care
6th Close the maintenance hatch. 4th Clean the water drainage hose
and the siphon socket.
Before the next wash
To prevent unused detergent from
flowing into the drain during the next
wash, run the program Pumping out
after you have emptied the drain
pump.
1. Open the tap.
2. Plug in the power plug.
3. Switch on the device.
4th Pour one liter of water into the
manual dispensing chamber.
5.
5. The program Pumping out start.
18.6 Clean the water drainage
hose on the siphon
If the water drainage hose on the
siphon is dirty or the detergent
solution is not pumped out, you must
clean it.
1. Switch off the device.
2. Disconnect the device's power plug
from the power supply.
3. Loosen the hose clamp and
carefully pull off the water
drainage hose.
18.7 Clean the filters in the
water inlet.
Empty the water inlet hose
To be able to clean the filters, first
empty the water inlet hose.
1. Turn off the tap.
2. The program cotton to adjust.
3. Start the program and let it run for
about 70 seconds.
Residual water can run out.
4th Switch off the device.
5. Disconnect the device's power plug
from the power supply.
60
To Next Page
Loading...
