Instructions, use and maintenance manual Pag. 33/49
SAU 160-200
The chain is loose when it admits clearance of the bowl with machine off. To tension the chain located
in the lower part of the machine, remove the lower base casing (see chap. 16.7).
To tension the chain, remove the locking screw (5) of the belt tightener tensioning plate (no.50 of the
table in chap. 16), rotate the plate and check the chain tension. Once tensioned, reinsert the fixing
screw (5) and tighten it, put the lower base casing back and test the machine.
After tensioning the chain, always check the tension of the bowl rotation motor belt.
To ensure the correct chain tension, see chap. 14.4.2
INTERVAL METHOD
s F,M
To adjust the tension of the lifter belt, tighten and/or loosen the central screw (6).
INTERVAL METHOD
s F,M
To Next Page
Loading...