Sigma 2-7 - Using the Centrifuge; Initial Start-up and Powering; Lid Operation

Laboratory centrifuge Sigma 2-7, Sigma 2-7 Cyto
Laboratory centrifuge Sigma 2-7 IVD
6 Using the centrifuge
26 / 68
Version 07/2015, Rev. 1.12 of 16/07/2019 • sb
Translation of the original operating manual, part no. 0702802

6 Using the centrifuge

6.1 Initial start-up
DANGER
• Before the initial start-up, please ensure that your centrifuge is properly
set up and installed (see chapter 5 - "Set-up and connection").
6.2 Switching the centrifuge on
• Press the mains power switch.
The display then illuminates. The centrifuge is ready for operation.
6.2.1 Opening and closing the lid
The lid can be opened if the centrifuge is at a standstill.
• Press the lid key in order to open the lid.
The centrifuge cannot be started if the lid is opened.
• To close, press with both hands slightly on the lid until the lid lock is
locked.
WARNING
Do not place your fingers between the lid and the housing when closing
the lid. Risk of crushing!