Sigma 2-7 User Manual

Laboratory centrifuge Sigma 2-7, Sigma 2-7 Cyto
Laboratory centrifuge Sigma 2-7 IVD
7 Malfunctions and error correction
Version 07/2015, Rev. 1.12 of 16/07/2019 • sb
39 / 68
Translation of the original operating manual, part no. 0702802

7.2 Table of error codes
Error no.
Kind of error
Measures
Note
1-9
System error
• Allow to slow down
• Power off/on
All these errors stop the
centrifuge or cause it to
decelerate brakeless
10-19
Speedometer error
• Allow to slow down
• Power off/on
20-29
Motor error
• Power off
• Ensure ventilation
30-39
EEPROM error
• Allow to slow down
• Power off/on
With error 34, 35, and 36, the
centrifuge will stop;
with error 37 and 38 only an
error message will be given
40-45
Temperature error
(only for refrigerated centrifuges)
• Allow to slow down
• Power off
• Allow to cool down
• Provide better ventilation (only
air cooled centrifuges)
• Provide sufficient water
throughput (only water cooled
centrifuges)
46-49
Imbalance error (only for centrifuges
with imbalance monitoring system)
• Allow to slow down
• Power off
• Eliminate the imbalance
50-59
Lid error
• Press lid key
• Close lid
• Remove foreign matter from
the opening of the lid lock
device
With error 50 and 51, the
centrifuge will stop
60-69
Process error
• Allow to slow down
• Power off/on
With error 60, the message
"power failure during run"will
be displayed, with error 61,
the message "stop after
power on" will be displayed
70-79
Communication error
• Allow to slow down
• Power off/on
80-89
Parameter error
• Power off
• Allow to cool down
• Provide for better ventilation
With error 83, error message
only
90-99
Other errors
• Check connections
• Provide sufficient water
throughput (only water cooled
centrifuges)
NOTE
If it is impossible to eliminate the errors, contact the service!

Sigma 2-7 Specifications

General

Brand	Sigma
Model	2-7
Category	Laboratory Equipment
Language	English