Sigma 2-7 - Page 66

Laboratory centrifuge Sigma 2-7, Sigma 2-7 Cyto
Laboratory centrifuge Sigma 2-7 IVD
Index
66 / 68
Version 07/2015, Rev. 1.12 of 16/07/2019 • sb
Translation of the original operating manual, part no. 0702802
Documentation ........................................... 10
E
Earth conductor check ............................... 22
EC declaration of conformity ................ 10, 59
EEPROM error ........................................... 39
Electrical connection ............................ 50, 51
Electrical safety .......................................... 18
Emergency lid release ............................... 38
Error correction .......................................... 37
Error message ........................................... 37
Explanation of the symbols and notes ........ 16
Explosive substances ................................ 19
F
Fatal error .................................................. 37
Fire preventions ......................................... 19
Form for the return of defective parts ......... 47
Functional and operating elements ............ 11
G
General conditions ....................................... 9
General malfunctions ................................. 37
Glass breakage .......................................... 43
Glass particles ........................................... 43
Glass vessels ............................................. 29
Gravitational field ................................. 50, 51
Grease for load-bearing bolts ..................... 41
H
Hazard warnings .............................. 9, 27, 29
Highly corrosive substances ...................... 18
I
Imbalance ............................................ 28, 29
Imbalance error .......................................... 39
Importance of the operating manual ............. 9
Important information ................................. 16
Infectious substances ................................ 44
Inflammable substances ............................ 19
Informal safety instructions ........................ 17
Initial start-up ............................................. 26
Input fuse ....................................... 12, 50, 51
Inspection by the manufacturer .................. 46
Installation of accessories .......................... 28
Installation of rotors and accessories ......... 27
Installation site ........................................... 25
Intended use ................................................ 9
Interrupting a centrifugation run ................. 31
Interrupting a deceleration process ............ 31
IP code ................................................ 50, 51
K
Kinetic energy ................................ 12, 50, 51
L
Layout of the centrifuge.............................. 11
Leaks ......................................................... 45
Lid cannot be opened ................................ 37
Lid error ..................................................... 39
Lid is not closed correctly ........................... 37
Lid lock device ........................................... 21
Lid lock has not released ........................... 37
Lid lock is not closed correctly.................... 37
Lid seal sticks ............................................ 37
M
Mains powerswitch off ................................ 37
Mains voltage ............................................. 18
Maintenance .............................................. 41
Malfunction ................................................ 37
Malfunctions and error correction ............... 37
Manual release of the lid lock ..................... 38
Manufacturer ........................................ 50, 51
Marking of the unit ..................................... 15
Measures in the event of hazards and
accidents ................................................ 22
Mechanical safety ...................................... 18
Mode of operation ...................................... 13
Motor error ................................................. 39
Motor shaft ................................................. 41
N
Name plate ................................................ 12
No indication on the display ....................... 37
No power in the mains supply .................... 37
Noise level ........................................... 50, 51
Nominal voltage ......................................... 12
Notes on safety and hazards ....................... 9
Notes on transport ..................................... 23
O
Online download of forms .......................... 48
Opening the lid ........................................... 26
Operating personnel .................................. 17
Operating voltage....................................... 25