Sigma 4-15C - Page 54

Operating Manual SIGMA 4-15C, page 54 of 95
03/06
5.1.3 Alteration of Program Parameters during the Centrifuge Run
During the run, the following values can be altered.
• Speed
• RCF
• Run time
• Switching into the continuous run mode/time mode
• Acceleration curve
• Deceleration curve
• Start delay
Alter the Set values as usual by activating the Alteration mode (refer to chapter
5.1 "Selection, Display and Alteration of Program Parameters").
You cannot change:
• Rotor
• Program
• Radius
• Density
The following functions can be activated/deactivated:
• Start delay
• Automatic lid opening after end of run