76
VIEWING IMAGES ON A TV
The SD10 camera can be connected to a television or a videocassette recorder
using the provided video cable, allowing the recorded images to be viewed on
the television monitor or recorded on videotape.
TO CONNECT THE CAMERA
TO A VIDEO DEVICE
1
Open the cover protecting the camera’s VIDEO
OUT, DC-IN, and IEEE-1394 connectors.
2
Connect the video cable to the ＜VIDEO OUT＞
terminal on the camera and to the video input
terminal on the television or video cassette
recorder.
3
Turn on the camera and the video device.
WARNING !!
• Please do not use any video cable other than provided with your Sigma SD10
camera, when connecting a video input terminal. Using other brands may cause
damage.
TIP
• It is recommended that the camera be powered with the provided AC adapter
during television playback to avoid draining the battery.
• The default mode for the video signal is NTSC. When connecting the camera to
a PAL device, the Video Mode setting in the Camera Set-up Menu must be
changed. (See P.96)
To Next Page
Loading...
Need help?
General
