Sigma SD10 - Mounting and Removing the Lens

23
MOUNTING AND REMOVING THE LENS
The SD10 camera uses SA type inside and outside bayonet mount (SA-IB and
SA-OB respectively).
1
Make sure to turn the “D”-Dial to OFF position
(Power Off position)
2
Remove the camera body cap and the rear cap
of the lens’.
3
Align the red mark on the camera’s mount with
the red dot on the lens. Insert the lens into the
mount of the camera, and rotate the lens
clockwise until it clicks into the locked position.
CAUTION !!
• To ensure a proper connection, do not hold down lens lock button while
mounting the lens.
• The SD10 camera contains a dust protector, located inside the lens mount. The
dust protector is a very delicate device. Take care not to cause scratch its
surface. Touching or pushing it with your fingers can easily damage it. If there is
dirt or dust on it, please refer to the Maintenance section of your manual (P.101).