MDD 121-1
10.03.2021 Page 11
2.5 Prescribed use
The servo drives of SIGMATEK GmbH & Co KG are developed and produced according to
the actual prior art. The products are fully tested before delivery, especially in terms of fail-
safe conditions.
They are components, which are built into electrical equipment and can only be used as
integral components of such equipment. Before the products are installed, the following
requirements must be fulfilled to meet the prescribed use.
• Anyone who works with the products in any way has to read and understand the
safety instructions, the prescribed use and the non-prescribed use.
• The machine builder has to generate a safety analysis for the machine to ensure
that unforeseen movements cannot cause injury or damage to personnel or
property.
• The servo drive has to operate under the mounting and installation conditions
described in this documentation, especially the environmental conditions
(temperature, protection class, humidity, mains input, EMC and the mounting
position)
• It must be mounted in a closed switchgear cabinet with minimum IP54.
• The servo drive has to be used in the way in which they are delivered (without
any mechanical or electrical modification).
• Do not mount or start-up mechanically or electrically damaged or faulty
components.
• The servo drive is intended to control synchronous servo, linear, torque and
asynchronous motors in closed loop control of torque, speed or position.
• The rated voltage of the motor must be at least as high as the setting of the
mains input voltage (230 V, 400 V or 480 V) of the servo drive system.
• Only motors with star-connection may be used.
• The servo drive is developed for usage in an industrial environment. If it is used
in residential areas, then an additional filter must be installed in the mains input
line.
To Next Page
Loading...
Need help?
General
