SII LP-1010 - Page 146

5-28
Manual feed + two-step roll model
When handling paper type No. as a paper supply type, paper supply is controlled as
listed below.:
Note) This setting is meaningless in applications not supporting the paper type No.
Paper type No. Paper supply control
0
Sets paper type No. = disable. Supplies paper according
to the panel paper supply mode setting.
1 Plot is produced on the normal paper.
2 Plot is produced on the tracing paper.
3 Plot is produced on the film.
4 and above
Sets paper type No. = disable. Supplies paper according
to the panel paper supply mode setting.
Paper type No. Paper supply control
0
Sets paper type No. = disable. Supplies paper according
to the panel paper supply mode setting.
1
Controls paper supply in the paper supply mode = roll 1
mode.
2
Controls paper supply in the paper supply mode = roll 2
mode.
3
Controls paper supply in the paper supply mode =
manual feed mode.
4 and above
Controls paper supply in the paper supply mode = roll 1
mode.