6-5
▼Setting items
Chapter 6 "DEVICE" menu
DOOR OPEN CUT
Specifies whether the plotting is started or not after the paper roll end is
automatically cut, when you plot the first data after opening and closing
the roll 1 or roll 2 door. Cutting width is 400 mm (15.7 inches).
◆ This function is used to cut the paper roll end using the cutter of
this device. Specify this function when you desire to cut the
paper end of output drawing cleanly.
<Parameter (choice input method)> : Default value
OFF Not cut.
ON Cut.
DENSITY
Adjusts the printing density.
<Parameter (choice input method)> : Default value
THIN/RATHER THIN/NORMAL/RATHER THIC/THICK
TRACING PAP. MODE
Specifies the environmental condition for tracing paper.
<Parameter (choice input method)> : Default value
NORMAL When using the print in normal environment.
WETTY When using the print in environment of high humidity.
To Next Page
Loading...