SII LP-1010 - Page 279

Appendix-25
▼ Command list
Appendix
dnammoC
noitcnuFtroppuS
emaNedoC
roloCdnuorgeroFCSE ✽ S|s#v
deificepsehtfoeulavBGRehtsteS
timilrewolehtotrebmun
xedni
.gnitnirpretsarfoeulav
×
mhtiroglAredneRCSE ✽ J|j#t
sserpxeotmhtiroglaseificepS
.atadenotflah
 (
7
)
roloCelpmiSCSE ✽ U|u#r.edomrolocsteS

nrettaPtnerruCCSE ✽ T|t#v.retsarehtotepytnrettapsteS
×
nrettaPdaolnwoD
CSE
✽ nrettap[W#c
]atad
.nrettapdenifedresusdaoL
×
lortnoCnrettaPCSE ✽ Q|q#c
denifedresufonoiteledseificepS
.nretta
p
×
DInrettaPCSE ✽ G|g#c.nrettapdenifedresufoDIsteS
×
ecnerefeRnrettaPCSE ✽ R|r#p.noitisopetsapnrettapsenifeD
×
noi
tarepOlacigoLCSE ✽ O|o#l
otedomnoitarepolacigolseificepS
.atadretsareht
 (
8
)
ycnerapsnarTnrettaP
edoM
CSE ✽ O|o#v
otedomycnerapsnartffo/nosnruT
.nrettapeht
×
ycnerapsnarTecruoS
edoM
CSE ✽ N
|n#v
otedomycnerapsnartffo/nosnruT
.retsarecruoseht
×
(2/2)
(
1
) Parameter value “-1” is treated as “0”.
Parameter values “-1 to 3” do not affect the palette information.
(
2
) Parameter values “0 to 3” do not affect the palette information.
(
3
) Partial page, even if present in received data, is not printed.
(
4
) Parameter “4” in the Set Pixel Encoding Mode is not supported.
Range assignable with the Set Number of Bit per Index is 1 to 8.
Range assignable with the Set Number of Bit per Primary is 0 to 8.
(
5
) Range of assignable parameter values is 0 to 31 (2**5-1).
(
6
) Pen width is not pushed/popped up.
(
7
) Effective parameter value of ESC*t#J is “0” only.
(
8
) ESC*I#O is effective only for part of logical operation to the monochrome binary raster.
Commands not listed in the table are treated as a command error or thrown away.