Silca SBB - Using the Machine: Communication and VAG PIN Code; Vehicle Communication and PIN Code Service Overview; VAG PIN Code Reading Procedure

Copyright Silca 2006 11
Operating Manual - English SBB
6.4.4 COMMUNICATION PROCEDURE WITH THE IMMOBILIZER
The following message appears :
The communication procedure with the immobilizer starts; if the car model selected is correct and the
immobilizer is detected, the
Functions menu by make appears , otherwise an error message is shown (see
chap. 8 "WARNING/ERROR MESSAGES", page 24).
6.5 PIN CODE SERVICE
This menu describes some of the functions required to obtain a PIN CODE (for certain vehicle models only)
without going to the dealer.
Select the item “
PIN CODE SERVICE ” and press ENTER .
The display will show:
- Use the Down/Up arrow keys to select the specific model, then press ENTER .
Press ESC to quit.
6.5.1 VAG PIN CODE
This function can read the vehicle PIN CODE directly from the OBD-II socket (only for certain VAG models).
Select “
PIN CODE SERVICE ” from the main menu, then “VAG PIN CODE ”.
The display will show:
6.5.1.1 DISABLED VEHICLE MODEL
If the function is not enabled a beep is heard and a message appears :
6.5.1.2 ENABLED VEHICLE MODEL
If the function is enabled the following message appears :
- Turn the key to the ON position.
Press any key.
Please wait
connecting...
- PIN CODE SERVICE -
VAG PIN CODE
VAG 7-4 PIN CONV.
> HYUNDAI PIN CODE
KIA PIN CODE
- VAG PIN CODE -
Device not enabled
for this model.
Insert password from
menu ENABLE FLAGS
(41)
Turn the ignition on!
Press any key...