Copyright Silca 2006 3
Operating Manual - English SBB
SBB - PAY PER USE CONFIGURATION
BASIC SOFTWARE
ACURA
®
,
ALFA ROMEO
®
, AUDI
®
, BUICK
®
, CADILLAC
®
, CHEVROLET
®
, CHRYSLER
®
, CHRYSLER
®
CAN,
CITROËN
®
, DODGE
®
, DODGE
®
CAN, EAGLE
®
, FIAT
®
, FIAT
®
-PSA, FORD
®
, FORD
®
AUSTRALIA, FORD
®
USA,
GENERAL MOTORS
®
BRAZIL, HOLDEN
®
, HONDA
®
, HONDA
®
USA, HYUNDAI
®
, JAGUAR
®
, JEEP
®
, JEEP
®
CAN,
KIA
®
, LANCIA
®
, LAND ROVER
®
, LEXUS
®
, LINCOLN
®
, MAZDA
®
, MERCURY
®
, MITSUBISHI
®
, MITSUBISHI
®
AUSTRALIA, MITSUBISHI
®
GREEK, MITSUBISHI
®
USA, NISSAN
®
, NISSAN
®
JAPAN, NISSAN
®
TRUCKS, NISSAN
®
USA, OLDSMOBILE
®
, OPEL
®
CAN BUS, PEUGEOT
®
, PONTIAC
®
, RENAULT
®
, RENAULT
®
CAN BUS, ROVER
®
,
SEAT
®
, SKODA
®
, SUBARU
®
, SUZUKI
®
, TOYOTA
®
, VOLKSWAGEN
®
, VOLKSWAGEN
®
BRAZIL, SPECIAL FUNCTION
ZZ-FNT 01, SPECIAL FUNCTION ZZ-FNT 02, SPECIAL FUNCTION ZZ-FNT 03, SPECIAL FUNCTION ZZ-FNT 04
.
- Two different methods are available for using the new makes:
SOFTWARE UPDATE (NEW MAKES RELEASED
)
To use the new makes downloaded with the SW update (after purchase) proceed only as follows
:
SOFTWARE UPDATE
The machine can be updated through an RS232 serial line connection with a personal computer.
POWER SUPPLY
-
From the car through an OBD II connector
;
-
From the car through the cigarette lighter plug
;
-
From the mains through a universal feeder and special cable
.
1.2 TECHNICAL DATA
POWER SUPPLY
-
8-45 Volt (typically 12Volt from the vehicle diagnostic inlet or cigarette lighter plug
).
-
Universal feeder
:
DIMENSIONS
Length: 220 mm
Width: 165 mm
Height: 50 mm
Weight: 300 g.
ENABLING BY
MODEL CHANGE
ENABLING BY TOKEN
By using an optional SMART CARD
“MODEL CHANGE” it is possible to
enable all the makes to use the basic
Software.
The card must be purchased and the
enablings have to be downloaded in
SBB by means of a SMART CARD (see
chap. 7 "MODEL CHANGE").
Use a credit that is reduced every time
key programming/deletion is carried out.
Credits can be purchased and loaded
onto SBB by means of a SMART CARD
(
see chap. 6.6.1 "ENABLING"
).
ENABLING BY TOKEN
Use a credit that is reduced every time
key programming/deletion is carried out.
Credits can be purchased and loaded
onto SBB by means of a smart card (
see
chapter “Enabling”
).
INPUT OUTPUT
Tension 90-264 Vac 15 Vdc
Current 1.0Arms @ 90V 1 A
Frequency 47-63 Hz
Power 15 W
To Next Page
Loading...