Silca SBB - Setup Menu: Enabling and Language; Enable Flags and Language Settings; Serial Number and Keys References

Copyright Silca 2006 15
Operating Manual - English SBB
6.6 SETUP
This section contains the various setting menus for the machine .
Select
"SETUP" from the main menu and press ENTER .
- Select and press ENTER .
6.6.1 ENABLING
After selection the display will show:
- Select IMMOBILIZER to view the vehicle makes available for entering enabling in the “Immobilizer” function;
- Select REMOTE CONTROLS to view the vehicle makes available for entering enabling in the “Remote
Controls” function;
- Select TOKEN to view the tokens available; further tokens can be loaded.
- Select and press ENTER .
ENABLING MAKES (FUNCTION AVAILABLE ONLY FOR SBB FULL LOAD DEVICES)
After selecting the menu “IMMOBILIZER or REMOTE CONTROLS” the display will show :
Select the required make to view the enabling levels available and those already enabled .
To enter the enabling password applied for with the document provided with the software update disk
(software application FORM
).
- Select the level of enabling and press ENTER .
-Select ESC to quit.
NOTE: the levels marked (*) are already enabled for operation.
- SETUP -
> 1 - ENABLE FLAGS
2 - LANGUAGE
3 - SERIAL NUMBER
4 - CALENDAR/CLOCK
5 - RELEASE
6 - STORE PASSWORD
7 - KEYS REFERENCES
- ENABLING -
> 1 - IMMOBILIZER
2 - REMOTE CONTROLS
3 - TOKEN (X)
- ENABLING -
> AUDI
FORD
NISSAN
OPEL
SEAT
- ENABLING MAKE -
LEVEL1 (*)
LEVEL2 (*)
> LEVEL3 (*)