24 Copyright Silca 2006
SBB Operating Manual - English
8 WARNING/ERROR MESSAGES
ERROR MESSAGE 1
ERROR MESSAGE N° 2
-
These error messages may appear during communication with the immobilizer if the connection is cut
off, or in the case of physical disconnection between the device and immobilizer: disconnect the device
from the socket and repeat the operation
.
ERROR MESSAGE 3
-
This message appears when a car model is selected but none of the queries from the different protocols
used receive a coherent reply from the immobilizer. Check that you have selected the right makemodel
.
ERROR MESSAGE 4
-
This message appears when the PIN CODE entered is not properly composed or is not recognized by
the immobilizer
.
- COMMUNICATION ERROR -
ECU
disconnected
Press ESC to quit
Communication error
Press any key...
Not recognized
protocol
Press any key...
NOT VALID
PIN
To Next Page
Loading...