Copyright Silca 2006 25
Operating Manual - English SBB
ERROR MESSAGE 5
This message appears when key programming is not successful. Repeat the procedure
.
ERROR MESSAGE 6
This message appears when remote control programming is not successful. Repeat the procedure
.
ERROR MESSAGE 7
- The key to be programmed is faulty, replace with a new key and repeat programming.
-
Press any key to continue
.
- All the keys memorized before programming started are still enabled for operation.
-
Press any key to continue
.
Key not programmed
Repeat procedure
Press any key...
REMOTE CONTROL
not programmed
Repeat procedure
Press any key...
- PROG.NEW KEYS -
KEY i
Acquisition failed
Key faulty
Repeat procedure
Press any key...
- PROG.NEW KEYS -
Procedure interrupted
Keys memorized before
procedure started are
enabled
Press any key...
To Next Page
Loading...