Silca SBB - Warning;Error Messages: Key Acquisition; Key Acquisition and Fault Error Messages; Disabled or Wrong Key Error Messages

26 Copyright Silca 2006
SBB Operating Manual - English
ERROR MESSAGE 8
- The key to be programmed is a wrong key, replace with the right key and repeat programming.
- Press any key to continue .
- All the keys memorized before programming started are still enabled for operation.
- Press any key to continue.
ERROR MESSAGE 9
- The key to be programmed has been erased and cannot be re-programmed. Replace with a new key and
repeat programming.
- Press any key to continue
- All keys memorized before programming started are still enabled for operation.
- Press any key to continue
- PROG. NEW KEYS -
KEY i
Acquisition failed
Key faulty
Repeat procedure
Press any key...
- PROG. NEW KEYS -
Procedure interrupted
Keys memorized before
procedure started are
enabled.
Press any key...
- PROG. NEW KEYS -
KEY i
Acquisition failed
Disabled key
Repeat procedure
Press any key...
- PROG. NEW KEYS -
Procedure interrupted
Keys memorized before
procedure started are
enabled.
Press any key...