Silca SBB - Warning;Error Messages: Key Status; Key Already Acquired Error Messages; Key Without Transponder Error Messages

Copyright Silca 2006 27
Operating Manual - English SBB
ERROR MESSAGE 10
- The key to be programmed has already been programmed; repeat programming.
- Press any key to continue .
- All keys memorized before programming started are still enabled for operation.
- Press any key to continue.
ERROR MESSAGE 11
- The key to be programmed is without a transponder. Replace with a new key with transponder and repeat
programming.
- Press any key to continue.
- All keys memorized before programming started are still enabled for operation.
- Press any key to continue.
- PROG. NEW KEYS -
KEY i
Acquisition failed
Key already acquired
Repeat procedure
Press any key...
- PROG. NEW KEYS -
Procedure interrupted
Keys memorized before
procedure started are
enabled
.
Press any key...
- PROG. NEW KEYS -
KEY i
Acquisition failed
Key not present or
without transponder
Repeat procedure
Press any key...
- PROG. NEW KEYS -
Procedure interrupted
Keys memorized before
procedure started are
enabled.
Press any key...