Silca Unocode 299 - Page 18

UNOCODE 299 Operating manual - English
14 Copyright Silca 2002
ATTENTION: when closing the clamp, do not apply excessive pressure
to the knob. Turning the knob approximately 70˚ (equal to
a force of 3NxM) is sufficient to secure the key (fig. 13).
Fig. 13
NOTE: before starting the cutting process the V100 clamps key gauge will automatically tilt itself to its
rest position.
U SING THE PINS
Copying with the optical reader
For keys with narrow stems the pins must be placed between
the bottom of the clamp and the back of the key so that the
key protrudes sufficiently out of the clamp and therefore can
be properly read and cut.
If the key has a narrow stem and is also very thin, 2 pins must
be used (see fig. 14).
Fig. 14
2 3 4
A
C
1
2
3
4
2
3
4
2
3
4
1