UNOCODE 299 Operating manual - English
22 Copyright Silca 2002
• Types of cut
All the data cards provided by Silca have the type of cut pre-set according to the original parameters.
The types of cut possible with UNOCODE 299 are: Normal, Flat, Laser and Vertical
.
NORMAL
For conventional car and door keys
.
FLAT
Mainly used for car keys where the cut edges are
rounded to facilitate the movement of the blades when
the key is put into the lock
.
L
ASER
Conjunction of the cutting angles is determined
automatically by the machine, allowing cuts to be made
with variable angles; this facilitates the smooth entry of
the key into the lock, prolonging the working life of the
key
.
V
ERTICAL
Necessary for special keys with small bits (Silca art. FO19P,
FO21P...) where a special cutter is required.
When this cutting method is used a special angled cutter
is needed
.
EXAMPLE OF HOW TO CHANGE THE TYPE OF CUT
:
All the technical data regarding the types of
cuts stored in the machine’s memory can be
changed according to the user’s requirements
.
1)
enter data card number (e.g.
: nr.50)
2)
before entering the cuts press the
combination of keys
SHIFT+ENTER.
3)
enter the “L” type cut by pressing the
SHIFT+L
keys
to set the laser type cut.
-
the letter in brackets (L) indicates the
type of cut recommended by Silca
.
NOTE:
for certain cutting methods the standard
cutter U01 must be replaced with a
specific cutter
(Ch.4.6 "Changing the
cutter", page 16).
4)
enter the combination and proceed with the
operations described in
ch.5.2, page 19.
N
P
L
V
V
Enter card number
STANDARD = 50
USER = 0
(ver. DB : 1)
Side 1 x 2 S. 50
. . . . . . .
Possible depths:
1234
S. 50
Cutter: U01
Cut type (L) = L
Alternative : N P
Side1x2 S.50
112233
Possible depths:
1234
ENTER
ENTER
ENTER
+
SHIFT
To Next Page
Loading...
