Operating manual - English UNOCODE 299
Copyright Silca 2002 23
• Changing the cutter
Some of the data cards stored in the machine’s memory require a different cutter from the standard U01
cutter.
EXAMPLE WITH FO21P key
:
Replace the cutter according to the instructions
in Ch.4.6 "Changing the cutter", page 16.
• Adapters
Some of the data cards provided by Silca may
show a new parameter (Adapt.: 7) which indicates
the type of accessory that is needed to cut the key
in question.
See the ‘Unocode Adapters’ leaflet included with
the Unocode 299 machine.
Enter card number
STANDARD = 0
USER = 0
(ver. DB : 1)
220
Side 1 x 4 S. 220
. . . . . .
Possible depths:
1234
ATTENTION !!
Install cutter:
05
Is cutter:
05
installed?
No = STOP Yes = ENTER
ENTER
ENTER
ENTER
Side 1
Clamp: 100/A Pos.: 0
Cutter: U01 Adapt.: 7
Pcs = 1/1 [START]
To Next Page
Loading...
