MPPT Charge Controller User Manual - Feb. 2019 16
5.5 PHYSICAL INSTALLATION
The Hybrid Boost Charge Controller should be installed in a wall using four screws with the panel
upright (if you can read the front panel text horizontally then this is correct).
The side panels and back are a heat sink to dissipate heat, which is why the orientation is important.
To guarantee the lifespan, it is suggested that the space around the device has no other items within
30cm.
1
st
Drill Size
2
nd
Fix the controller on the wall with M4 screw
3
rd
When fix the screw, try to shift the screw driver about 10 angle
To Next Page
Loading...