SilentWind MPPT HYBRID BOOST CHARGE CONTROLLER User Manual

MPPT Charge Controller User Manual - Feb. 2019 26
5.8 CHECK LIST
Before getting the Hybrid Boost Charge Controller started, check the correct mounting and installation
according to the following check list:
Electric Installation
Enough ventilation is provided?

The electrical connections (crimping) were done correctly?

All wires are correctly placed?

The wires have the correct cross section: Silentwind generator and battery?

The fuse was installed between the Hybrid Boost Charge Controller and the battery?

Hybrid Boost Charge Controller
Fastened securely to the mounting location?

All screw terminals firmly tightened?

6. OPERATION
If windspeed is enough, the Silentwind generator should start charging. You can control this on the
LCD display of the Hybrid Boost Charge Controller or from your smartphone or tablet using Silentwind
generator APP available on Android and iOS devices.
To brake the Hybrid Boost Charge Controller manually, press the button for 5s to activate the brake
status.
If the End of charge voltage and/or the Brake Storm Voltage values is/are reached, the
Silentwind generator will stop for approximately 10 minutes. After that period, the charge
controller will check if it’s safe to turn the Brake to Off.
If the capacity of the batteries is less than 150 Ah, or old batteries that have lost their
original capacity, the point of max. voltage can be reached very fast although the battery
is not fully charged yet. In this case it can be useful to connect an electric consumer to
the Load-output, as this will reduce the voltage and thus prevent that the break mode is
activated too early.

SilentWind MPPT HYBRID BOOST CHARGE CONTROLLER Specifications

General

Brand	SilentWind
Model	MPPT HYBRID BOOST CHARGE CONTROLLER
Category	Controller
Language	English