The above table is for standard GEL and AGM batteries. Costumers must always check
the battery manufacturer settings recommendations.
The End of Charge Voltage is critical.
The Storm Brake is critical.
Silentwind cannot be held responsible for bad parameter settings that might permanently damage
your batteries, your charge controller and your wind generator.
If you need to change the parameters, it can be done directly on the Hybrid Boost Charge Controller
or through APP.
5.7.1 SCAN BUTTON
How the SCAN button works:
Press momentarily to change between screens
Press for 2s to enter SET mode (LCD shows “SET”, settings will vary according to the screen),
pressing again for 2s will exit and save the SET mode
Pressing the scan button on SET mode will adjust the parameters
Press de button for 5s to turn the Brake On
Press the button for 8s to fix the voltage degree, and then you can enter the setting
interface after it shows “24” or “12”. (Not recommended, leave it as it is)
Press the button for 10s to reset to factory defaults and the 8888 number will be displayed
on the LCD. Stop pressing the button and then click it momentarily to turn the charge
controller to normal operation.
The value is looped through several parameters. So, if the value you want to set is less than
the one it showed on the LCD at present, you just need increase it and let it back to the
small value you need.
To Next Page
Loading...
Need help?
General