8.1 Chronograph Mode - Using the Chronograph
Chronograph Function
To Record a Lap Time
To Reset the Chronograph
!
!
!
!
!
In 'Zero' Display, press the [set] button once
to start the counting. When it is counting,
press the [set] button again to stop the
counting, and the elapsed time of which the
chronograph is counting will appear.
When the elapsed time is displaying, repeat
the key operations above to get the
accumulative elapsed time or press the
[reset] button to reset the chronograph.
Check the below 'To Reset the Chronograph'
section for more detail on how to reset the
chronograph.
When the chronograph is counting in the
previous operations, press the [reset] button
to display Lap Time Display for 10 seconds.
When the Lap Time is displaying, the
chronograph remains counting in the
background.
To reset the chronograph, to be ready for a
new operation, press the [reset] button once
when the chronograph has stopped counting.
The display will then return to 'Zero' Display.
CHRONO
GRAPH
00
0:00.00
CHRONO
RUNNING
01
0:00.00
CHRONO
RUNNING
011L
0:00.00
CHRONO
STOP
20
0:00.00
Note:
This diagram illustrates the
general flow among different
functional displays only, and
may NOT conform to fact in all
instances.
[set]
[set]
[reset]10 seconds
[reset]
Chronograph Mode
('Zero' Display)
Chronograph Mode
(Counting Display)
Chronograph Mode
(Lap Time Display)
Chronograph Mode
(Stop Counting Display)
counting
Lap Time
(the chronograph
is counting in the
background)
Lap No.
Elapsed Time
(the chronograph
is stop counting)
To Next Page
Loading...
Need help?
General
