Calibration Setting Display
18.3 8.3
TEMP C8
0.0
OFFSET
Temperature Calibration Display
18.3 8.3
TEMP C8
0.0
OFFSET
hold [reset][mode]
the offset
value
current
temperature
wind chill
temperature
Temperature Mode - Calibrating the Temperature12.7
To Select Setting Display
The Setting Sequence
!
!
!
!
Following the previous '
' section to select
the Calibration Display.
In the Calibration Display, press and hold
the [reset] button for 2 seconds to select the
Calibration Setting Display.
When the 'offset value' digits are flashing,
press the [set] or [reset] buttons scroll
through to select target offset value (hold
down the button to scroll the setting at a
faster pace).
When the above settings finished, press the
[mode] button once to exit the setting
sequence.
1) When the temperature has been calibrated,
the ADC will offset the current temperature
by the target offset value. For example:
If the offset value is +2 and the current
temperature is 26 degrees C, the ADC will
display 28 degrees C (26+2).
2) The current wind chill temperature will be
updated as above accordingly.
Setting the Wind
Chill Temperature Alarm
Note:
[set]hold [set][reset]hold [reset]
Select the
setting by
backward scrolling
Select the
setting by
forward scrolling
Select the setting by
backward scrolling
(fast scrolling)
Select the setting by
forward scrolling
(fast scrolling)
To Next Page
Loading...
Need help?
General
