Altimeter Mode - Setting Relative Air Density14.7.3
To Calibrate the Altitude
!
!
!
!
Following the previous 'Altimeter Mode
Setting Sequence' to enter the Relative Air
Density Setting Display.
When the one of the settings (temperature,
pressure and relative humidity) is flashing,
press the [set] or [reset] button to scroll by 1
to select the target value (hold down the
button to scroll the setting faster).
When the above settings finished, press the
[mode] button once to exit the setting
display, press and hold the [mode] button
for about 2 seconds to exit the setting
sequence or press the [mode] button to set
the other settings.
1) hen the above Relative Air Density setting
has been set, the Relative Air Density and
the Absolute Air Density will be calculated by
this setting.
2) The standard default values in the RAD
settings are 15.0° C, 1013.3hPa and 0%
RH.
Note:
Temperature
Setting
Pressure
Setting
Humidity
Setting
RAD SETTING
TEMP C8
RAD SETTING
BARO hPa
RAD SETTING
HUMIDITY
15.0
1013.3
80%
[mode]
[mode]
[mode]
[mode]
[set]
hold [set]
[reset]
hold [reset]
Select the
setting by
backward scrolling
Select the
setting by
forward scrolling
Select the setting by
backward scrolling
(fast scrolling)
Select the setting by
forward scrolling
(fast scrolling)
temperature
pressure
relative
humidity
Relative Air Density Setting
To Next Page
Loading...
Need help?
General
