Silver King SKBD3LS - Initial Cleaning and Sanitizing; Component Preparation; Sanitization Process

Printed in USA 10/13 © 2013 6 36948-EN
3-Product Dairy Dispenser
Model SKBD3LS
P R I NC E C A STL E LLC
WORLDWIDE
Initial Cleaning and Sanitizing
All product tanks must be cleaned, sanitized and air dried
before use.
CAUTION
Make sure the power switch is in the OFF position.
1
Open the front and top access doors of the unit.
2
Open the product valves. Open the three product
valves by pulling out slightly and turning
counterclockwise a quarter of a turn, parallel to the
dispensing tube slot.
Valve Shown in
Closed Position
Valves Shown In
Open Position
3
Remove shipping spacer (cardboard flat) from
under the tanks.
4
Soak the tanks and covers. Place the tanks and
covers in the three compartment sink, filled with a
Dunkin approved dairy dispenser detergent, making
sure to follow manufacturer’s specifications for
detergent use. Let soak for 5 minutes.
5
Clean the tanks and covers. Thoroughly brush-clean
the tanks and covers. Make sure any film is removed
from internal and external surfaces.
6
Thoroughly rinse the tanks and covers in warm
water.
7
Sanitize the tanks and covers. Rinse the tanks and
covers in the sanitizing solution for a minimum of one
minute. Remove from sanitizing solution, shake to
remove excess solution and place the parts on a clean,
dry surface to air dry.
8
Sanitize the slots and valves. With an approved
sanitizing solution, thoroughly clean the dispensing tube
slots and dispensing valves. Allow to air dry.
9