Silvercrest 113373 - Working with the Kneading Hook, Beater and Whisk

7
SKMP 1300 B3
GB
IE
Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fingers in the mixing bowl 
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit is at a complete standstill!
After being switched off, the drive continues
to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
CAUTION – PROPERTY DAMAGE!
► When working with kneading hooks ,
whisk - or beater 3, we recommend
allowing the appliance to cool down after
10 minutes of operation.
NOTE
► When you are working with the kneading
hook , whisk - or beater 3, the drive unit
lid 1 must be in place. If not, the appliance
will not start.
To prepare the device for tasks involving the knead-
ing hooks , whisk - or beater 3, proceed as
follows:
1) Push the release lever  upwards and move
the swivelling arm  to the highest position.
2) Insert the mixing bowl  so that the locking
mechanisms on the mixing bowl  fit into the
recess in the base . Rotate the mixing bowl 
clockwise (cf. symbols
and
on the
base ) until it is locked and stable.
3) Depending on type of application, mount either
the kneading hook , whisk - or beater 3
onto the drive shaft :
– Place the kneading hook , whisk - or
beater 3onto the drive shaft  so that
both metal pins on the drive shaft  fit into
the recesses in the inset -3.
– Push the inset -3 firmly onto the drive
shaft  until the spring is compressed while
rotating the inset a little anticlockwise (direc-
tion
).
– Let go of the inset. It is now firmly attached
to the drive shaft .
4) Add the ingredients you wish to process to the
mixing bowl .
NOTE
► Please note that the dough in the mixing bowl
 will increase in volume or will be pressed
upwards by the movement during the kneading
or mixing process. Therefore, never fill the
mixing bowl  to the brim!
5) Push the release lever  upwards and push
the swivelling arm  into its working position
with the mounted inset facing downwards.
6) Push the lid  onto the mixing bowl .
IB_113373_74_SKMP1300B3_SE_DK_BE_NL.indb 7 29.06.15 15:03
DIN A5 148 mm x 210 mm