Silvercrest 113373 - After You Have Finished Using Your Appliance; Working with the Blender

8
SKMP 1300 B3
GB
IE
NOTE
► If desired, you can mount the filling nose 
onto the lid :
– Rotate the lid  a little until the opening
is pointing at you.
– Hook the filling nose  into the eyelets
in the lid :
You can now add ingredients, even while the
device is in operation.
7) Turn the rotary switch  to the required setting
(cf. section “Speed Levels”).
After you have finished using your
appliance
1) Switch the appliance off using the rotary
switch .
2) If mounted, remove the filling nose .
3) Remove the lid  from the mixing bowl .
4) Push the release lever  upwards and move
the swivelling arm  to the highest position.
5) Remove the inset -3 from the drive shaft
 by pushing the inset -3 against the
drive shaft  and simultaneously rotating
it clockwise (direction
). Now you can
remove the inset.
6) Remove the mixing bowl  by rotating it
anticlockwise and lifting it off the base.
7) Clean all parts of the appliance (see section
“Cleaning and care”).
Working with the blender
WARNING! RISK OF INJURY!
► Allow hot fluids to cool to a lukewarm temper-
ature (approx. 30–40°C) before pouring
them into the blender 0.
WARNING! RISK OF INJURY FROM
SHARP BLADE/ROTATING DRIVE!
► Never put your hand into the blender 0
while it is attached!
► Only remove the blender 0 when the blade 6
is at a complete standstill.
► Only use the blender 0 with the lid . with
measuring cup !firmly in position.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
CAUTION! PROPERTY DAMAGE!
► Never use the mixing bowl  and the blender
0 simultaneously! This will overload the
drive!
► When working with the blender 0, we
recommend allowing the appliance to cool
down after 3 minutes of operation.
Proceed as follows to prepare the appliance for
operation using the blender 0: Refer to figure C
on the back flap.
1) Push the release lever  upwards and push
the swivelling arm  down into its working
position.
IB_113373_74_SKMP1300B3_SE_DK_BE_NL.indb 8 29.06.15 15:03
DIN A5 148 mm x 210 mm