Silvercrest 113373 - Adding more Ingredients; After You Have Finished Using Your Appliance; Cleaning and Care

9
SKMP 1300 B3
GB
IE
2) Pull off the drive unit lid 1.
NOTE
►
Ensure that the rotary switch is set to the
"0" position before fitting the blender onto
the drive unit
. Otherwise, the appliance will
start automatically as soon as the blender is
locked in.
3) Place the blender 0 onto the blender drive
unit + so that the locking mechanisms on the
bottom of the blender 0 fit into the recesses
in the blender drive unit +. The arrow on the
blender 0 must point to the
symbol on
the appliance. Rotate the blender 0 clockwise
as far as it will go. The arrow on the blender 0
will then point to the
symbol on the appli-
ance.
4) Add the ingredients.
5) Place the blender lid . with measuring cup !
onto the unit, making sure that the lip on the
lid . seals the spout.
6) Turn the rotary switch  to the required setting.
NOTE
► The optimal speed depends on the consistency
of the food to be processed. More liquid
contents can be blended faster.
► For short, powerful pulses, set the rotary
switch at least to level 1 and simultane-
ously press the PULSE button . The PULSE
button  does not lock, in order to avoid
overloading the drive. Therefore, hold the
PULSE button  in this position only for a
short period.
Adding more ingredients
1) Switch the appliance off using the rotary
switch .
2) Remove the blender lid . and insert the
ingredients.
or
3) Rotate the measuring cup ! situated within the
blender lid . 90° and remove it. Then gradu-
ally add the ingredients using the opening.
After you have finished using your
appliance
1) Switch the appliance off using the rotary
switch .
2) Rotate the blender 0 anticlockwise until the
arrow on the blender 0 points to the
symbol on the appliance, then remove it.
NOTE
► Ideally, you should clean the blender 0 im-
mediately after use (see the section "Cleaning
and care"). This makes food residues easier
to remove.
Cleaning and care
DANGER – ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
NEVER immerse the appliance in water or
any other liquid!
CAUTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These may damage the surfaces
of your appliance.
IB_113373_74_SKMP1300B3_SE_DK_BE_NL.indb 9 29.06.15 15:03
DIN A5 148 mm x 210 mm