RECOMMENDED TOOLS & TEST
EQUIPMENT
The following list of Tools, Electrical Engineering Test Equipment and Materials are
required to carry out the Assembly procedures contained in this document.
TOOLS
Electric Drill (preferably with Hammer Action).
a. 7.5 mm Drill Bit.
b. Spirit Level.
c. Pozidriv Screwdriver.
TEST EQUIPMENT
a. Anritsu/Wiltron S331A Test Set.
b. Earth Bonding Test Set.
c. Dummy Load.
d. Wattmeter (50 Ω Test Set).
CABLES
a. USB Cable.
b. Ethernet Switch Cable.
MATERIALS
a. 4 x M4 x 12 Screws (supplied).
b. 4 x Rawlplugs (supplied).
c. 4 x No. 12 x 1½” Woodscrews (supplied).
d. M6 x 12 mm Pan Head Pozidriv Retaining Bolts.
e. M6 x 16 mm Pan Head Pozidriv Retaining Bolts.
f. M6 Nuts and Plain Washers.
g. Plastic Cup Washers.
h. M6 Cage Nuts.OTHER ITEMS
i. Personal Computer (PC) with the following Software Applications
installed:
SOFTWARE
a. System Digital Management Terminal (SDMT).
b. IP Configuration Tool
Doc Number: TNM-I-E-0041 Revision 1.6 Page 17
To Next Page
Loading...
Need help?
General
