b. From the menu options, select ‘Base Operations’ > ‘Reboot Base(s)’
option. The ‘Reboot Bases’ warning message will be displayed.
c. On the Reboot Bases warning message, select ‘Yes’ to continue.
d. In the Comms History area, confirm that a ‘Starting Resetting Base’
message is displayed and, after a short delay, confirm that a ‘Completed
Resetting Base’ message is displayed.
e. The Reboot operation of the relevant base station will now take place.
22. On the System I/O page, in the System Monitor area, on the navigation tree,
carry out the following:
a. To enable all the bases on a system, carry out the following:
i. Right click on the VAC that you wish to enable. Menu options will be
displayed.
ii. From the menu options, select ‘Site Options’ > ‘Enable Site(s)’. The sites
enable warning message will be displayed.
b. To enable an individual base, carry out the following:
i. Right click on the Base that you wish to enable. Menu options will be
displayed.
ii. From the menu options, select ‘Base Operations’ > ‘Enable Base(s)’. The base
enable warning message will be displayed.
c. On the relevant warning message, select ‘Yes’ to continue.
d. In the System Monitor area, on the navigation tree, confirm that the
status notification that was alongside the relevant VAC, Site or
individual base has now disappeared.
Doc Number: TNM-I-E-0041 Revision 1.6 Page 52
To Next Page
Loading...
Need help?
General
