SRP9100 ~ PMR Portable Radio User Guide
© Comgroup Australia 2010 23 TNM-U-E-0047 Issue 1.2a
6.1.4 Contrast
The Contrast Screen allows you to set the
contrast level of the Display in the range from 0
to 15.
Use the -/+ to select the required level.
Press OK to accept the setting and go to the
Channel Screen.
Note: this option currently not available.
6.1.5 Alert Volume
This Screen allows you to set the level of the
Alert Volume Beep Tone in relation to the current
Volume setting. The level can be set in 63 steps
over the range -31 to +30, with 0 being about the
same as the voice level.
Use the - /+ buttons to change the relative alert
level. The beep will sound at the indicated level
each time the setting is changed.
Press OK to accept the setting and go to the
Channel Screen.
Note: A minimum Alert Level may be set to
ensure the Alerts can always be heard
from the speaker.
6.1.6 Information
This Screen displays information that identifies the Programmer File
description, Software Version and Radio Serial Number.
This is a read only Screen, press OK to go to the Channel Screen.
6.1.7 Network
The Network Screen allows you to switch
operation between;
• Trunk Network 1
• Trunk Network 2 or
• PMR.
Use the -/+ buttons to make your selection.
Press OK to accept that selection and go to the selected mode.
Refer to the Trunk Operating Instructions for Trunk operation.
M12
Contrast
To Next Page
Loading...
Need help?
General
