SRP9100 ~ PMR Portable Radio User Guide
TNM-U-E-0047 Issue 1.2a Page 24 © Comgroup Australia 2010
7. SPECIAL FUNCTION BUTTONS
This section lists Functions that may be programmed to the F1, F2, F3, F4, F5
F6 or F7 buttons.
Consult your Simoco Dealer for which functions have been programmed in to
your radio.
7.1 M
ONITOR
Opens/Closes the audio (signaling) mute.
Only valid on Non-Community Repeater type channels and/or Closed Selcall
channels without Receiver Lock-out programmed.
7.2 S
QUELCH
D
EFEAT
Opens/Closes the squelch (carrier) mute.
7.3 R
ESET
Closes the audio (signaling) mute on closed Selcall Channels.
7.4 S
CAN
Activate Scanning, refer to Section 5.5.
7.5 S
END
-2
Sends a specific selcall sequence.
7.6 T
RANSPOND
D
ISABLE
Disables Individual Call Acknowledge. When pressed, a single beep indicates
on and two beeps indicate off.
7.7 CTCSS
Defeats the CTCSS mute on the channel
Only valid on Non-Community Repeater type channels and/or Open Selcall
channels.
7.8 M
UTE
Provides direct access to the Mute Setup screen (refer to Section 6.1.2) and
allows the user to change the mute level from that screen.
7.9 G
OTO
C
HAN
A, B, C, D
Selects predefined Channel A, B, C or D, and may return on the second press.
The Defined Channel may be redefined if held for approximately 2 seconds.
Field programmer configuration will affect the previously described behaviour.
7.10 S
PECIAL
E
NC
1…8
Sends Special Encode 1, 2, … 8
To Next Page
Loading...
Need help?
General
