8-1
When an abnormal condition occurs, a record of the event is placed in one of two logs
generated by the system, depending on the nature of the condition. These logs are:
• Historical Alarm Log
• Historical Fault Log
The historical logs contain a time stamp of the events surrounding abnormal conditions in the
system. The information displayed with these lists are historical data only and will not contain
any current point status. Separate lists are maintained for alarms and for isolates/faults. This
chapter describes displaying and clearing these lists.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Viewing and Clearing the Historical Alarm and Fault Logs 8-2
Chapter 8
Viewing and Clearing Historical Logs
Introduction
In this Chapter
To Next Page
Loading...
