APPENDIX B
SPECIAL INSTRUCTIONS FOR RACK-MOUNT MODEL (6400 ONLY)
General Notes
1. For frame mounting, attach the four #lO screws supplied by Simplex (see Step 9 below).
2. For slide mounting, the following hardware (or equivalent) is recommended (see Mounting Instructions - Slides
& Cable Carrier below and instructions supplied with slides and cable carrier):
A. 2 - Slides (Vendor Part No. CC-3700)
VENDOR:
Chassis Trak Electronic Slide Mechanisms
Division of General Devices Electronic Hardware Manufacturers
P.O. Box 39100
Indianapolis, Indiana 46239
(317) 897-7000
NOTE: Order slides that are two inches shorter than rack depth, i.e., if rack depth is 18 inches, order 16-inch slides.
B. 1 - Cable Carrier (Vendor Part No. D-329)
VENDOR:
Vent Rak Electronic Cabinetry
(also a Division of General Devices - see address above)
NOTE: The above cable carrier must be used to supply strain relief for all incoming wires to the 6400.
When attaching cable to the cable carrier, use cable ties which are supplied with 6400.
Mounting Instructions - Slides & Cable Carrier
NOTE: See Figure 45 for Steps 1 through 6.
1. Remove 6400 top cover (A) by removing the four No. 6 screws (B) - two on each side.
2. Using hardware supplied with slides, attach one inner mounting rail (C) to either side of 6400 chassis (D).
NOTE: Locking mechanism (E) on inner mounting rail should be positioned towards rear of chassis.
3. Repeat Step 2 for remaining inner mounting rail.
4. Using hardware supplied with rear mounting bracket (F), attach one rear mounting bracket to outer mounting
rail (G).
5. Repeat Step 4 for remaining rear mounting bracket and its outer mounting rail.
6. Using supplied hardware, attach outer mounting rails to rack rails (not shown).
NOTE: Ensure that rear mounting brackets are attached to rear rack rails.
7. Using supplied hardware, attach cable carrier (H) to rear rack rail and rear of 6400 chassis. See Figure 46.
NOTE: Ensure that grounding wire (J) is attached to 6400 chassis (Figure 46).
8. Replace top cover by replacing four screws (B). See Figure 45.
9. Attach four # 10 screws (K) to 6400’s front brackets, two on each side, to keep 6400 from sliding out of its rack
(Figure 45).
NOTE: Four #lO screws (K) are supplied with 6400.
36
To Next Page
Loading...
