Simplex 6351 User Manual

SSimplex
6351 and 6400 Time Control Centers
Installation/Operating Instructions
I995 Simplex Time Recorder Co.
MC6-21-100 (574-403)
I specifications and other information shown were current as of publication, and are subject to change without notice.
Ed 12 95
firealarmresources.com

Simplex 6351 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	6351
NAC Outputs	4
Frequency	50/60 Hz
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH at +90° F (+32° C)

Summary

Section 1: Pre-Power Adjustments

General Notes for Pre-Power Adjustments

General guidance and notes for performing pre-power adjustments on the TCC.

Setting DIP Switches on CPU Board

Configure CPU board DIP switches for output formats and timekeeping.

Setting DIP Switches on 6400/6351 Coded/Impulse Boards

Instructions for setting DIP switches on optional Coded/Impulse boards.

Setting DIP Switches on WWV Interface Board

Configure WWV Interface Board DIP switches for communication settings.

Section 2: Installation Wiring

General Notes for Installation Wiring

General guidelines and safety precautions for wiring the Time Control Centers.

Connections to Power/Interface Board

Detailed wiring diagrams for the Power/Interface Board connections.

Connections to Impulse Interface Board

Connecting the Impulse Interface Board for secondary clock operations.

Connections to 6800 Coordinated Universal Time Receiver

Wiring procedures for connecting the TCC to a 6800 Time Receiver.

Connection to Extended Battery (Optional)

Steps for connecting an optional extended battery to the TCC.

Final Checkout Procedure

Steps for post-installation checks, including power application.

Section 3: Operating Manual Override Switches (Standard Equipment)

Manual Override for ON/OFF and PULSE Events

Using manual override switches for ON/OFF and PULSE events on the 6400.

Manual Override for DELAY Events

Using manual override switches for DELAY events on the 6400 TCC.

Manual Override for SYNCHRONOUS Output

Controlling synchronous clock output using manual override switches.

Manual Override for GENERATOR Output

Operating manual override switches for the generator output function.

Manual Override for SERIAL BCD Output

Using manual override switches to control the serial BCD output.

Section 4: Operating Manual Override Switches (Optional Equipment)

Manual Override for Remote Relays (Circuit 1)

Operating manual override switches for remote relays on optional equipment.

Manual Override for Secondary Clock Output

Controlling secondary clock output using manual override switches.

Appendix A: General Mounting Instructions

Mounting Procedures for TCC Back Box and Components

Steps for mounting the TCC back box, retainer panel, and ground strap.

Appendix B: Special Instructions for Rack-Mount Model (6400 Only)

General Notes for Rack-Mounting

General considerations for rack-mounting the 6400 Time Control Center.

Mounting Instructions for Slides & Cable Carrier

Detailed steps for installing rack-mount slides and cable carrier for the 6400 unit.

Appendix C: WWV Interface Board Installation Instructions

Installing the WWV Interface Board

Steps for installing the WWV Interface Board into the TCC unit.

Appendix D: 6351 Keypad Operation and Basic Keypad Entries

Introduction to Keypad Operation

Overview of the 6351 keypad and its role in time setting procedures.

Keypad Operation Details

Explains keypad modes, normal active/inactive states, and basic entry logic.

Basic Keypad Entries for Time and Date Setting

Instructions for setting hour format, time, day of week, and date using the keypad.

Programming Automatic Daylight Saving Time Changes

Procedure for programming automatic DST changes on the 6351 Time Control Center.