Simrad AP26 Manual&Nbsp;

Simrad AP26 and AP27 Autopilots
30 20221586B
Regain manual steering by pressing the STBY button
Setting the waypoint arrival circle
For route navigation it is recommended to use automatic
waypoint shift/change at a set waypoint arrival circle.
The arrival circle should be adjusted according to boat speed.
The higher speed, the wider circle. The intention is to make the
autopilot start the heading change in due time to make a smooth
turn onto the next leg.
The figure below may be used to select the appropriate waypoint
circle.
Example: With the speed of 20 knots you should use a waypoint
circle with radius 0.09 nm.
Note ! The distance between any waypoints in a route must not be
smaller than the radius of the waypoint arrival circle when using
automatic waypoint shift.

Simrad AP26 Specifications

General

Brand	Simrad
Model	AP26
Category	Autopilot System
Language	English