SimNet network, small system
SimNet network, small system with Wind transducer
12V supply
Ter mination
not required
Tee Joiner
Tee Joiner
12V supply
* The supply cable and wind transducer have a built-in terminator.
*
*
* The supply cable has a built-in terminator.
CX33
CX33
CX34/44/54 NavStation Installation 1 - 19
SimNet power and termination
The following simple rules should be observed when installing SimNet:
• SimNet must be powered with 12 VDC and connected to the battery via
circuit breaker and 5 amp fuse.
• Do not connect the SimNet power cable to the same terminals as the
Autopilot Computer, Radar, thruster or other high current products.
• SimNet should normally be terminated in each end, starting with the power
cable with termination in one end and termination plug or wind transducer
(with termination) in the other end.
To Next Page
Loading...
