To Next Page

To Previous Page

Chapter 7-12 EQ33 Setup menu

Call up the menu bar, and...

5,7

activate the display for Factory settings

FACTORY PRESETS:

Return to NMEA presets

Return to SOUNDER presets

CLR

Return to all factory presets

Show test display

Exit

To activate any of the above-mentioned functions, please follow the

instructions in the display. However, any attempt to make any type

of change, will first of all generate a WARNING display to inform

you that you are about to erase some or all data/settings.

ENT

If you are absolutely sure, press [ENT] to complete the job

If not absolutely sure, press [MENU] to exit function without having

made any changes

POWER OFF - RESET

In case, for some reason, the unit is totally locked i.e. no immediate

response from the keypad, then first try to reset the unit by discon-

necting the power supply. Reconnect the power cable and then start

up the unit again by presssing and holding the [PWR] key until a

picture appears on the screen.

MASTER RESET (will return all settings to factory presets)

If the Power off - reset does not solve the problem, you may have to

perform a master reset by disconnecting the power supply, and then

while reconnecting the power cable you will have to press the [PWR]

and [CLR] keys at the same time, and hold both keys depressed until

a picture appears on the screen. All user-made data will be erased,

and all settings are returned to factory presets.

Simrad EQ33 User Manual

Questions and Answers: