Simrad Maris ECDIS900 - Installation and Troubleshooting; General; Oftware Nstallation and Ettings

General
Installation and Troubleshooting
GENERAL
The system is delivered ready to use and no installation is necessary. However, the user may
have to re-install a new version of ECDIS900.
Installing the software:
• Insert the Installation DVD into the DVD-DRIVE or use the installation usb flash drive.
• Open the DVD: double click on My Computer and on the DVD drive icon or open the
usb flash drive
• Double click on the folder disk 1
• Double click on the file Setup.exe and follow the instructions of the set-up program.
NOTE
•
If a previous version of the ECDIS900 is installed on the hard
disk, the set-
up program saves the Sensor_Monitor
configurations, installed charts, routes and tracks.
•
Once the ECDIS900 application installed on the hard disk,
several folders containing the application, utilities and data
have been created.
Launch and quite ECDIS900
as described below.
•
ECDIS display is type approved device and should be used with
factory settings. Software does not require screen resolution
and colour mode, but it is strongly recommended to use
resolution no less than 1280 * 1024.
•
In case the Win 7 OS the Windows Classic Theme must be set. In
case of using another theme, some GUI colours could be
inconsistent.
In case of
technical problems
or to order new charts please contact the
MARI S support
.
OPERATIONAL LIMITS
Operational limits
of ECDIS900 listed in the proper section.
TESTS
Regular tests
should be performed on board to check that the system works properly.
SOFTWARE INSTALLATION AND SETTINGS
The system is delivered ready to use and no software installation is necessary.
62