Autopilot
Settings in Expert mode
• Send data to IP port specifies main output UDP port to which is sent Extractor/Tracker
data
• Destination host specifies destination mode for this port. Smart broadcast means that
Sensor Monitor broadcasts data if there is network connection, otherwise it sends data to
127.0.0.1.
• Use following data sources tree shows all usable data presented in the network. Data
are grouped first by their kinds and then – by sending host. Only one data of each kind
can be chosen. By default Sensor Monitor chooses first coming data of each kind, but the
user can change this layout.
• Send also received data directly from the sensor specifies if Master or Slave Sensor
Monitor that receives some Extractor/Tracker-related data must send them out directly
from the sensor (immediately when received) instead of normal data dispatching.
• Internal ET data route port specifies UDP port that is used to send Extractor/Tracker
related data internally from Slave Sensor Monitors to Master Sensor Monitor. If Local
routing is switched on (applicable for standalone installation only) this routing will be
completed only for the local PC.
• ET track data output port specifies UDP port to read set and drift information
• Force sensing the following data allows Sensor Monitor to send some kinds of data
even they are not present in the input data flow (in this case data will be filled with zeros).
AUTOPILOT
The ECDIS can be interfaced with standard NMEA compatible auto pilots and with different
Track pilots including Emri Track pilot.
33
To Next Page
Loading...
